COMMANDS LIST FOR FUSE EXT2 HOW TO
COMMANDS LIST FOR FUSE EXT2 INSTALL

You can open it and read from it just like any other disk, card, or flash drive you connect to your Mac. Now you'll see the rpi volume mounted in the Finder. See this issue: Unable to open ext4 mounted partition on El Captain. The -o allow_other is required to make sure the mounted disk is readable by everyone (and not just the sudo/ root user). Mount the drive using ext4fuse: sudo ext4fuse /dev/disk4s2 /Volumes/rpi -o allow_other.The ID is the disk4s2 in my case, in the IDENTIFIER column.Ĭreate a 'mount point'-a folder on your Mac where you will 'mount' the Linux partition so you can read data from it: sudo mkdir /Volumes/rpi ( sudo requires you to enter your Mac account's admin password, since it performs actions with elevated privileges-enter your password when prompted.) You should be able to tell which drive is your Pi drive by the description ( external, physical), the 'Linux' partition type, and the size of the disk (e.g. Use Disk Utility on the command line to find the Raspberry Pi's partition ID run diskutil list to get output like below: $ diskutil listĢ: Apple_HFS Macintosh HD 499.3 GB disk0s2ģ: Apple_Boot Recovery HD 650.0 MB disk0s3

COMMANDS LIST FOR FUSE EXT2 INSTALL

brew install ext4fuse (Note: This seems to not work as of late 2021 see this issue).

Using Homebrew, install osxfuse and ext4fuse (find out more about the tools on the FUSE for macOS website):.

Make sure you have Homebrew installed (instructions here), so you can install the tools you need to mount the filesystem.

The boot volume will be automatically mounted, but it doesn't contain all the files from the Pi's primary filesystem. Plug the microSD card into a card reader connected to your Mac.

COMMANDS LIST FOR FUSE EXT2 HOW TO

Here's how to mount the Raspberry Pi's ext4 filesystem on a Mac (almost everything will be done in the Terminal app (in Applications > Utilities)): Luckily, there are open source tools that allow ext4 filesystems to be mounted on a Mac (read-only, but that's all I need to copy off the time-lapse stills and video). But this is annoying, because dd will back up the entire microSD card, not just the data I want. In the past, I would use the dd utility to back up the entire card, and then I would mount that backup disk image and read data off of it. This is normally a bit tricky, because the Raspberry Pi uses the Linux ext4 filesystem-which is not compatible with either macOS or Windows! So I decided to finally try to mount the Raspberry Pi's drive directly on my MacBook Pro (running macOS Sierra 10.12).

which means it could take a couple hours to copy). For my Raspberry Pi Time-Lapse App, I find myself having to either copy hundreds (or thousands!) of 3+ MB image files, or a 1-2 GB video file from a Raspberry Pi Zero W to my Mac.Ĭopying over the WiFi network works, but it's extremely slow (usually topping out around 5 Mbps.

Commands list for fuse ext2